The bottle cannot be removed from the mold after blowing.

First, the blow mold should be opened, and the mold should be opened and closed manually. If it is normal, run it in the dry running state, if it is normal.

Please check your exhaust time setting. If the exhaust setting is normal and the blow-up bottle fails every time, then it can be judged that the exhaust valve is a problem. Please open the exhaust valve to check the condition of its springs and seals (this Another kind of failure is that the exhaust sound is relatively loud or there is an unclean sound).

If you encounter a situation where many molds are produced normally and you can't open the mold, please check if there are screws in the clamping pin, and check if the clamping force is too large. Standard readjusted.

Bottles are always pinched

Whether the position of the robot is misaligned.

Two robots collide

This situation requires manual resetting of the robot, which is caused by misalignment