Semi-Automatic Beverage Bottle Blow Molding Machine

1. After the machine is transported to the bottle blowing machine factory , first check whether the parts of the machine are loose and whether the electrical wiring is firm. If it is loose, it should be tightened. 2. The machine must be installed on a level floor. Adjust the foot screws to keep the machine level. 3. The electrical part uses a single-phase 220V power supply. The cross-sectional area of the power cord must be greater than 1.5mm2. At the same time, the machine must be well grounded to ensure personal safety. 4. The air source used by the machine is divided into two channels. The air source of the control circuit is connected by a cross-section 10mm2 air pipe. The pressure of the air source should be able to maintain 0.8-1.0Mpa. The working pressure should be adjusted to reduce the pressure.