Welcome To - Taizhou Huangyan Yige Machinery Co., Ltd.!Home - contact us - Online Message

Call Us on

15967672923
15967672923
Category
contact us

Company Name: Taizhou Huangyan Yige Machinery Co., Ltd. Contact: Manager He Phone: 15967672923
Company mailbox: 2562261439@qq.com
Company Address: Shangye Industrial Zone, Jiangkou Street, Huangyan District, Taizhou City

Industry knowledgeYou are here: Home - Industry knowledge - Content
Bottle blowing machine factory reminds you about the semi-automatic model
Edit:Taizhou Huangyan Yige Machinery Co., Ltd.   UpDate:2018-08-20

Taizhou Huangyan Yige Machinery Co., Ltd. is a professional blow molding machine manufacturer specializing in the production of stretch PET bottle blowing machines and preform molds. Since its inception, the company has been committed to this area of expertise. It mainly provides planning for customers, from preform design to blow molding,

1. Check whether each emergency stop switch, safety door switch, and protection device detection switch are normal.
2. Check whether the heating head enters the embryo and whether the part of the embryo is working normally. If the insert is not in place, the nut can be adjusted.
3. Before starting each shift, lubricating oil must be added to each moving part. (Manipulator, manipulator guide, mold opening and closing guide)
4. Swing arm can be added once every day (3-4). The large and small chains of the heater can be used once a month. Frequently check whether the reducer of the main engine and the reducer of the heater is short of oil. The host bearing can be added once every (2-3) months.
5. Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact force is strong, and whether the belt drive part is abnormal.
6. Check whether the pneumatic components are leaking and the action is sensitive.

7. Check whether the high-pressure gas source, low-pressure gas source, power source, and water source are normal.
8. Check whether the tube is damaged or broken. To be replaced in a timely manner.

PET automatic blow molding machine operation matters-as the name suggests is the operation process. PET automatic bottle blowing machine is a bi-directional stretching process during the blowing process. During this process, the PET chain is bi-directionally extended, oriented and aligned, thereby increasing the mechanical properties of the bottle wall and improving the stretching and tensile strength. , Impact strength, and has good air tightness. Although stretching helps increase strength, it should not be stretched too much. Control the stretch inflation ratio not to exceed 3.5 to 4.2 in the radial direction and not to exceed 2.8 to 3.1 in the axial direction. The wall thickness of the preform should not exceed 4.5mm. PET automatic blow molding machine equipment is carried out between the glass transition temperature and the crystallization temperature, generally controlled between 90 to 120 degrees. In this interval, PET shows a high elasticity, and it becomes a transparent bottle after rapid blow molding and cooling and setting. PET automatic bottle blowing machine during the blowing process: from stretching to secondary blowing, the two action time is very short, be sure to coordinate and adjust: stretching start timing, stretching speed, pre-blow start And the timing of completion, pre-blowing pressure, pre-blowing gas flow, etc., if possible, it is necessary to be able to control the overall temperature distribution of the preform and the temperature gradient of the inner and outer walls of the preform. During the rapid blowing and cooling process, induced stress is generated in the bottle wall. For inflatable beverage bottles, it can resist internal pressure and is beneficial, but for hot-filled bottles, it must be guaranteed to fully release above the glass transition temperature.

Previous: What is a 10L bottle blowing mold

下一条: No Information

Mobile