Welcome To - Taizhou Huangyan Yige Machinery Co., Ltd.!Home - contact us - Online Message

Call Us on

15967672923
15967672923
Category
contact us

Company Name: Taizhou Huangyan Yige Machinery Co., Ltd. Contact: Manager He Phone: 15967672923
Company mailbox: 2562261439@qq.com
Company Address: Shangye Industrial Zone, Jiangkou Street, Huangyan District, Taizhou City

Industry knowledgeYou are here: Home - Industry knowledge - Content
Injection Molding Factory Explains the Preparation of Hollow Blow Molding Machines Before Starting
Edit:Taizhou Huangyan Yige Machinery Co., Ltd.   UpDate:2019-02-18

Before the hollow blow molding machine is driven, it is necessary to strictly prepare for driving. The main contents are the following eight points:

One point: the cooling water of the cooling material needs to be turned on, and this phenomenon is very common.

Second point: preheat the hydraulic oil. If the temperature of the hydraulic oil in the oil tank of the hollow blow molding machine is too low, the heater should be turned on immediately, which is provided on a large machine.

The third point: press the start button and park immediately to check whether the pump is running in the correct direction. If it is found that it does not correspond to the two-phase lead motor power line immediately.

The fourth point: the machine should be opened without pressure in the hydraulic system. After opening, adjust the pressure of the overflow system of each pump to a safe pressure. In large injection molding machines, there are often two pressure systems, one is a mold clamping unit, the other is an injection unit, and each of the two units has a pressure release space. After the pump is stopped, this pressure vent valve must be opened. When the pump is in operation, it is necessary to close the c switch.

Fifth point: Adjust the orientation of all the strokes to make the moving template clear the c switch.

Sixth point: Close the thorough door. When opening the safety door on the operation side, it is required to comply with the safety protection requirements. V All safety doors should be closed during operation. For large hollow blow molding machines, the closing of the fishing mold is prevented: if the further safety door is opened, the oil pump will stop working.

Seventh point: Turn on the heating and temperature conditioning system.

Eighth point: It is necessary for the device mold c to clean the mold surface and the contact surface with the mold of the hollow blow molding machine.

Ninth point: The hollow blow molding machine is turned on the main switch of the control cabinet L, and the operation selection switch is set to the anti-rust oil in the jog or manual 1.

Taizhou Huangyan Yige Machinery Co., Ltd. is located in Huangyan, a coastal city in Zhejiang, China. After years of pioneering and development, our factory has a number of blow molding machine technology patents, and a specially developed one-out, two-speed, energy-saving, fully automatic bottle blowing machine, leading the domestic production of linear machines with a single cavity. The company is a professional manufacturer of bottle blowing machines, plastic bottle blowing machine manufacturers, plastic mold manufacturers, injection mold factories.

Mobile