Company Name: Taizhou Huangyan Yige Machinery Co., Ltd. Contact: Manager He Phone: 15967672923
Company mailbox: 2562261439@qq.com
Company Address: Shangye Industrial Zone, Jiangkou Street, Huangyan District, Taizhou City
Common problems in the blowing process of automatic bottle blowing machine
1. Feeding old card feed tray: This situation is a headache. From experience, if the length of the preform (embryo) is longer and the weight is larger, then this phenomenon is relatively small.
2. Do not feed at the feeding level: check several conditions: 1), whether the hopper is out of material, if it is: you need to add the material quickly; . If it is a power-on condition, check whether the motor is under power and load status as soon as possible. Because this condition is likely to be caused by the preform (embryo) jamming the lifting belt, at this time, the simple method is to manually assist the lifting; If you check that the control contactor of the hoist is not energized, please check whether the detection eye of the preform is not on the same line as the reflector.
3. The bottle always pinches the manipulator to check whether it is misplaced.
4. After the bottle is blown, it cannot be taken out of the mold.
First of all, the mold should be opened, and the mold should be opened and closed manually. If it is normal, run it in dry running condition, if it is normal.
Please check your exhaust time setting. If the exhaust setting is normal, and only one bottle blowing is required every time, then you can determine the problem of the exhaust valve. Please open the exhaust valve to check its spring and seal. Condition (This phenomenon is also a phenomenon of loud exhaust sound or unclean noise).
If you encounter a situation where many molds are produced normally and you can't open the mold, please check if there are screws in the clamping pin. Otherwise, check if the clamping force is too large. If it is too large, you should Adjust from scratch according to the standard.
5. The two robots collide: This situation requires manual reset of the robot from the beginning, which is caused by misalignment.
Previous: Be sure to understand the technical process of the blow mold
下一条: Analysis of the blowing process of the automatic blowing machine