Welcome To - Taizhou Huangyan Yige Machinery Co., Ltd.!Home - contact us - Online Message

Call Us on

contact us

Company Name: Taizhou Huangyan Yige Machinery Co., Ltd. Contact: Manager He Phone: 15967672923
Company mailbox: 2562261439@qq.com
Company Address: Shangye Industrial Zone, Jiangkou Street, Huangyan District, Taizhou City

newsYou are here: Home - news - Content
Normal maintenance and common faults of automatic blow molding machine
Edit:Taizhou Huangyan Yige Machinery Co., Ltd.   UpDate:2019-02-25

Daily maintenance of blow molding machine

1. Able to slide the guide rod and change the butter once every two days.

2. Mould filler, once a week.

3. Heat the track and blow the bottle track, add liquid lubricating oil depending on the situation.

4. Mop the inside of the mold with a clean cloth dipped in alcohol once a week. Usually observe whether the bottle body has pits with particle depressions, and then remove the mold adhesion to the corresponding position of the mold.

5. Usually pay attention to the body of the bottle blowing machine, the interior is clean and tidy, and the stolen goods are removed in time.

6. Pay more attention to the orientation of the screws of the moving parts and the electronic sensors, and tighten or correct them in time if they are loose or displaced.

7. Shut down the machine's air inlet valve for a long time. Such as rear repair equipment, eating and so on. The production line has been shut down for a long time, and the main power supply of the machine must be closed. The company's primary production of automatic bottle blowing machine

1. Light box water channel high temperature alarm.

Treatment method: Disassemble the rubber pipe connected to the water channel, purge and clean the water channel with low-pressure gas and alcohol.

2. Claw problems

Treatment method: adjust the height of the sliding table, or the orientation of the gripper.

3. Action is stuck.

Solution: Restart the machine.

4. Unable to manually origin

Treatment method: Check whether the shifting one jaw, the shifting two jaw and the variable pitch positioning plate are locked in the corresponding orientation. If not, manually lock them to the corresponding orientation and then the origin.

5. Action is not in place

Solution: Check if something is stuck. Conditioning gas flow valve 6. Exhaust sound is too loud

Treatment method: check whether the high-pressure exhaust muffler is damaged or dropped

Treatment method: adjust the orientation of the embryo bucket. The company mainly produces fully automatic blow molding machines