Welcome To - Taizhou Huangyan Yige Machinery Co., Ltd.!Home - contact us - Online Message

Call Us on

15967672923
15967672923
Category
contact us

Company Name: Taizhou Huangyan Yige Machinery Co., Ltd. Contact: Manager He Phone: 15967672923
Company mailbox: 2562261439@qq.com
Company Address: Shangye Industrial Zone, Jiangkou Street, Huangyan District, Taizhou City

newsYou are here: Home - news - Content
Bottle blowing machine manufacturers teach you how to maintain and maintain the bottle blowing machine
Edit:Taizhou Huangyan Yige Machinery Co., Ltd.   UpDate:2019-06-17

If the blow molding machine can be used for a longer time, the indispensable is the maintenance and maintenance of the blow molding machine. Below, the blow molding machine manufacturer will introduce to us how to maintain and maintain the blow molding machine.

1. The feeding level is not feeding: There are several situations that need to be checked: whether the hopper of the blow molding machine is out of material, the assumption is: the demand is fast, and the feeding is not: please check whether the control contactor of the progressive machine is receiving electricity. Electricity situation, quickly check whether the motor is receiving power and loading. Because this situation is likely to be caused by the preform (embryo) stuck in the progress zone, the simple method at this time is to manually help the progress. Assuming that the control contactor of the progressive machine is not energized, check whether the preform detection sensor is not on the same straight line as the reflector.

2. Feed the old card and feed tray: This situation is a headache. From the perspective of experience, it is assumed that the length of the preform (embryo) of the blow molding machine is relatively long and the component is large, then this phenomenon is relatively small. of.

3. After the bottle is blown, it cannot be taken out of the mold. First of all, the mold should be opened, and the mold should be opened and closed manually. It is assumed that it is normal. If it is running in idle mode, it is normal. Please check your exhaust timing settings. Assuming the exhaust setting is normal and you only need to blow the bottle every time, then you can determine the problem of the exhaust valve. Please open the exhaust valve to check its springs and seals. (There is also a phenomenon of this kind of problem is that the exhaust movement is relatively large or there is an unclean discharge movement). Suppose you encounter a situation where many molds are produced normally and you can't open the mold. Please check if there is a screw in the clamping pin. For others, please check whether the clamping force is too large. Standard readjusted.

4. Whether the bottle always pinches the manipulator or not.

Mobile